Recent content by rodder55

  1. R

    Tow/Haul mode, LMM Swap in an 84 C30

    I got all the diagrams at my disposal. Bonus to have a good buddy work at Gm. I'll give it a shot. U might have a im in the future if I get hung up think I got a good idea just never actually executed a project of this type . Have a complete donor truck do getting all matching modules Ect isn't...
  2. R

    Tow/Haul mode, LMM Swap in an 84 C30

    Any incite on how this is done same idea as stand alone engine power grounds ignition and should work or any kinda thing it needs . I'm putting an 09 lmm into 95 h1. Wanna keep cruise tap shift and tow haul if you have info I could compensate you for knowledge as stand alone bcm is new to me. Thanks
  3. R

    LLY Build, bare necessities

    If u were to build it for 600hp id use delipped lly pistons on lbz rods but a used motor is ur best bet
  4. R

    My Build Has Started!

    Pm me ur cell I'll text ya
  5. R

    My Build Has Started!

    I got good factory one in ponoka. I'll Be picking my motor up next week could maybe drop it off
  6. R

    LBZ: Engine Build

    I would they are cheap ur build looks similar to mine Right down to the twins
  7. R

    Which piston rings to use

    Oh no wish I never seen this thread haha I though my stock rings were good on my lbz for my build using cut lb7. Can I run them or should I switch to 2010+ rings
  8. R

    Allison 6sp: Code P0700 and P0762

    Mine was a twisted stator iirc
  9. R

    Stabilitrac module

    I'm doing an 03 escalade esv 1/2 tonn swap I am using an Lly and was looking for price for ur niffty little module thanks
  10. R

    Aftermarket headunits and Bose LUX Amp

    I love my PAC with my lux great sound go for it
  11. R

    DIY LBZ stand alone

    Oh that's good to no I had no idea gm would be so sneaky
  12. R

    DIY LBZ stand alone

    Pretty tap shift just a momentary push button.
  13. R

    P0762 P0757 Trans Limps When Put Into Drive

    I'm betting something isn't assembled right I'm sure mike l will chime in. Have u double checked fluide level and wiring. Unplug main connector into trans see if u got 3rd forward gear?
  14. R

    Allison 6sp: P0741

    What should I look for loose tone wheel? What should I data log and look for.output speed sensor? Commanded gear and actual gear?
  15. R

    Allison 6sp: P0741

    Hey mike what is the main cause of these. Stator issues pretty sure mine slipped the splines heard a loud bang on lock up with my gmax6 with PI ML now p0776 Replace the whole stator and shaft or is there a fix? Thanks for any insight
See more
Top Bottom