Recent content by Loco-Mechanic

  1. L

    2007 Classic Allison Shift Range Inhibited

    Sent you a text Carter :thumb:
  2. L

    2007 Classic Allison Shift Range Inhibited

    Getting ready to head out the door for work, so I'll get in touch with you when I get back. Probably Friday or Saturday if that's ok.
  3. L

    2007 Classic Allison Shift Range Inhibited

    Wasn't sure what it would be worth with a bad trans in it. If I could get 7K for it as it sits, I'm not against that. Damn things are still fetching 15 to 17K running.
  4. L

    2007 Classic Allison Shift Range Inhibited

    Thanks James! I don't mind doing the work, just need some guidance. I'm sure thorough cleaning of the valve body would be in order as well, since all these little solenoids/valves can screw up with even the littlest piece of debris. Ended up buying a new truck today, so this will give me time to...
  5. L

    2007 Classic Allison Shift Range Inhibited

    Pulled the pan and there is a lot of clutch material in the bottom, and the fluid has a greenish tint to it. even with all the fluid that's been run through it onto the ground. :o Who's a good source for either a rebuild kit, or even another trans? I would like to tackle the rebuild myself...
  6. L

    2007 Classic Allison Shift Range Inhibited

    OK thanks guys.. truck does have 200,000 miles almost. I'm sure I didn't do it any favors.
  7. L

    2007 Classic Allison Shift Range Inhibited

    OK, let's see if I can explain this. Drove down the street and popped a trans cooler line off. Didn't know at the time that it happened. (Only drove a half mile) Was stopped idling for a while in park,(Filling 500 gallon water tank) went to put it in drive to leave, and no go, and CEL was on...
  8. L

    Golden Valley/Kingman AZ help needed

    After I started it, because it won't start with the connector unplugged, I pulled the connector, and no, it still doesn't go forward, but it will slam hard into reverse. I'll start a new post over in the trans section, once I find out what the codes are. I don't want to waste anyone's time...
  9. L

    Golden Valley/Kingman AZ help needed

    Yes, oil level is good. I even over filled it a little to make sure. All started when it blew a cooler line off. I refilled it just to get it home around the corner, but didn't quite make it. Towed it the rest of the way to the house, and now only reverse works. I have no way to pull trans...
  10. L

    Golden Valley/Kingman AZ help needed

    I'll give it a try. At this point I'll try anything.
  11. L

    Golden Valley/Kingman AZ help needed

    I can't drive it at all. Only has reverse, shift range inhibited, happened after a tranny cooler line blew off the other day.
  12. L

    Golden Valley/Kingman AZ help needed

    Here I am!!! Thanks Roger!!
  13. L

    Installed the B&W GN Turnover Today (pics)

    I had to get it done, so I could take the Dodge out from under the trailer and get it sold. Hey, I had to take pics too. Plus, did you see my working conditions? Laying in dirt and gravel sucks...lol Good idea.. tomorrow
  14. L

    Installed the B&W GN Turnover Today (pics)

    Installed my B&W turnover into my (wife's) 07 Classic today. :thumb: Quite the project I must say. Nice that the hitch is AMERICAN made, and has directions you can understand.. :coffee: Took every bit of 8 hours to install this thing. Of course I spent an hour just trying to get the very...
  15. L

    Guess I'll reintroduce myself

    Picked it up today. Man what a nice running truck. It's got some power compared the 12 valve Cummins I have now. Really impressed with the fuel mileage coming home. I never got below 70 (except going through the small towns) and I hand calculated the mileage at 19!!! That is pretty damn good for...