Lennydmaxguy's latest activity
-
And the cost of having these tools on hand is why good Indy shops should not be afraid to charge appropriately. The cost of tooling up a... -
Lennydmaxguy replied to the thread Snap On vs. Autel.I have both brands in my shop and the Snap-on tools come out of the drawer multiple times a day, while the Autel is maybe used once a...
-
Lennydmaxguy replied to the thread weird fuel pressure issues.Have you adjusted table B1012? That is an idle specific table.
-
Thank you for all the information, truck pass smog. Replace the pcv diaphragm and no more smoke when I rerouted back to stock.
-
Still doesn't seem like a wide spread problem. So I still have faith in the Duramax. Definitely take it iver a Ram right now. Ford seems...
-
You pick your poison these days. You could have got a ford and have the cp4 explode, intercooler tube blow out, injector valve seals...
-
Lennydmaxguy reacted to PureHybrid's post in the thread Current record for the Oval Race Cast pistons! with
Haha.
That's how you make those new fangled dimple pistons without removing them from the engine -
Lennydmaxguy reacted to kidturbo's post in the thread Current record for the Oval Race Cast pistons! with Haha.
Nice info. I've seriously tried my best to kill em. Smacking 6000R's free spinning, directly into 100% load, 1750F sustained, like for...
-
Lennydmaxguy reacted to MarkBroviak's post in the thread Paul Vasko's new Dmax RailCar makes its Debut Technical info Thread! with Like.
Ok, so to dig into the data on this machine! This car is rocking 3.25 gears with 33x14.5x15 Hoosiers on a hardtail chassis. The 4L80E...
-
Lennydmaxguy reacted to MarkBroviak's post in the thread Paul Vasko's new Dmax RailCar makes its Debut Technical info Thread! with Like.
This thread is a technical inside look at what we are doing and how we are doing it with this new project of Paul's! I hope you guys...
-
Lennydmaxguy replied to the thread Failed visual test.Yes, the plate comes off with the 4 Phillips screws. The picture 2004LB7 attached above shows correct install order. The spring fits...
-
Lennydmaxguy replied to the thread Failed visual test.You'll need to remove the plate to know for sure. The rubber flange and spring are the important parts here.
-
Lennydmaxguy replied to the thread Failed visual test.Yes, and I should add, getting that tube wouldn't be a bad idea either. They might want to see all original parts to pass the visual...
-
Lennydmaxguy replied to the thread Failed visual test.This is the diaphragm I mentioned. Looks like you can get replacements...
-
Lennydmaxguy replied to the thread Failed visual test.Actually, that is nothing but a tube with a Y connection. The "Positive" part of the system is a little diaphragm on each valve cover...