Recent content by DTT933

  1. DTT933

    01-10 steering box redhead ,PSC ,OEM

    I was able to order a Cardone 978418GB off Rock Auto last week Thursday and it came this weekend. It is a 6 bolt like the image showed on their site for anyone else looking
  2. DTT933

    6 speed to 5 speed swap!

    I'm not looking to go too much over stock. I will most likely just do a single tow type tune. I have a stock replacement turbo with billet wheel and 25% SAC injectors for the engine. New head gaskets and studded. This is just a work truck that is used for work around the farm and towing...
  3. DTT933

    6 speed to 5 speed swap!

    Appreciate the suggestion, sounds like thats what I will do after I get the trans out and bellhousing pulled. After inspection, if needed, is there a suggested C3 clutch pack to go with for my general use? Along with the C3 pack, should I bother doing the TranGo Jr with Mikes trim springs and...
  4. DTT933

    6 speed to 5 speed swap!

    Perfect. Thanks for the response. I wasn't sure of there was any recommendations as far as doing/upgrading to make things more reliable etc. I have a cracked bell housing on an LB7 I've been freshening up so figured if there were any sort of suggestions while I had that apart it'd be a good time...
  5. DTT933

    MI Hello

    Hello, I've been lurking around a while and have found a lot of useful info, so I figured Id join in. I'm from SE Michigan and have always been a gearhead with muscle cars, hot rods and motorcycles being my focal point, but have been messing with Duramax vehicles for the past 6 years or so. I...
  6. DTT933

    6 speed to 5 speed swap!

    Not to hijack, but what is recommended for use in a 5 speed? I've seen conflicting info related to a benefit of the JR kit. Or is that TG kit paired withthe Mike L trim springs the ticket? Will the addition of the shift valves and ratiotek PR spring be beneficial in a regular use type truck? Thanks
See more
Top Bottom