Recent content by DmaxKnightmare

  1. DmaxKnightmare

    LBZ vs LML

    What is the general consensus on running 60 over injectors on a stock cp3. Dont want to replace my cp3, if that is NEEDed for 60s. I'll put 45s in if i have to and not run as big of tune!
  2. DmaxKnightmare

    LBZ vs LML

    Do earlier model heads go on an l5p shortblock? Im sure they dont but..... sure would be sweet if they did. I was looking at a not far from new l5p motor that came out of a wrecked truck but didn't think it would work.
  3. DmaxKnightmare

    LBZ vs LML

    Wheres the recommended place for injectors?
  4. DmaxKnightmare

    LBZ vs LML

    I appreciate the help! I sent my injectors off to get tested and received my results today. All injectors failed by just a little bit. Like 1 # on the full load test. So i am probably gunna need to replace them. Thats definitely the right thing to do. Im using a very well known and good rated...
  5. DmaxKnightmare

    LBZ vs LML

    I emailed wagler on the matter too. They said they wouldnt put a lml rod in. They would stick with a lbz/lmm rod. I would assume its because of the smaller rod end or whatever on the lml rods and pistons. Ive finally found a set of pistons that will get here before October, and they are delipped...
  6. DmaxKnightmare

    LBZ vs LML

    I have a LLY that cracked a piston and i am tearing into it now. I was gunna just replace pistons, doing all the stuff needed for that. But when i removed one of the rods from the piston, the wrist pin bushing turned in the rod. So basically i dont think its worth using these rods. I have...
See more
Top Bottom