who else works on 5000+hp engines

[adrenaholc1]

Anyone on here work on emd or ge diesel engines. Looking for someone with knowledge about locomotive engines.

 

[MadMaxx61]

Anyone on here work on emd or ge diesel engines. Looking for someone with knowledge about locomotive engines.

I cut the blocks lol

EMD 710's V8,V12,V16, and V20

GE L8, L6 and the EVO-12

I even do the older EMD H-Case and a shit load of others lol

http://www.duramaxdiesels.com/forum/showthread.php?t=36537

 

[adrenaholc1]

So you cut the sheet metal that makes the block? Where at?

 

[adrenaholc1]

The new 12cyl evos are bad mo foes. I love listening to them idle when they drop 6 cyls out. Output=4400hp notch 8.

 

[MadMaxx61]

So you cut the sheet metal that makes the block? Where at?

Well not the sheet metal the EMD 710's are the non-cast block we used to do a lot of the air-boxes (in side the block) then we shiped them to EMD they wield it all into the ruff block then we machine it to size then ship them back to EMD for assembly. The V20 in the photo in the thread I linked to was ready to ship back to EMD.

Here is a photo of 2 raw V16 EMD H-Cases and 2 V16 EMD 710's getting shipped out.

We also go Waukesha v12's and v16's


Tecumseh Ontario Canada.

 

[countrycorey]

I was an engineer on a tandem engine/generator setup at a power plant for about a year