Viewing TCM & ECM in Scantool V7.5

[Chris611]

I have BBL setup and it works well. Been using it for a couple years. I have PIDs from both the ECM & TCM. Both controllers log fine together and I can view them on the Scantool Dashboard.

Now I want to view those PIDs in Scantool on the dashboard live. I can't figure out how to get Scantool to allow me to live view both TCM and ECM pids. Any thoughts?

Thanks.

 

[x MadMAX DIESEL]

Idk if you can do that. I always do bbl and never figured out how. Quit trying because frankly I don't need to do that


Sent from my iPhone using Tapatalk

 

[DAVe3283]

I don't believe you can do that. If I recall, they claim that is a feature that will be released with their V8 scan software eventually. But for now, you have to BBL, sadly.

I really wish you could get TCM PIDs from V7.5, it would make certain things easier when using my RoadRunner for realtime tuning.

 

[THEFERMANATOR]

The v7.5 software as far as I know is constrained to only displaying 1 controller at a time. BBL uses the v8 type of software, and can display both as you have figured out. Hopefully they get the v8 software up and going, byt I know software development for new and current controllers keeps them very busy.