So I just tried to fit the Kodiak turbo inlet on with the ProFab Y Bridge and it wont clear by about 3/8" I was thinking I could cut it down and bond a piece to cover it or go with some aftermarket unit.
Thoughts?
Thoughts?
Turbo Inlet's
- Thread starter stibuilder
- Start date
I got too side tracked and didnt take any once i put the turbo on. I just dont want to waste money on the AFE if its known not to work on trucks with the Y bridge. The one picture I took was before I put the turbo on.
Not sure if i should weld on an extension or just try and make this work but once a coupler and clamp go on I will need even more space.
Why couldnt you just pull the y bridge and change the angle of the inlet and reweld it? You dont need much to make everything fit. It looks like you have room from the picture. Is another accessory blocking you from doing that?
I must be having this issue because of the Kodiak inlet, It might just be easier to put a truck one on, or an aftermarket one. Seems like plenty of guys have Y Bridges and this works fine. If it was an inch longer id be set. I honestly don't want to pull the bridge because if I do a HSP or SDP might go back in its place $$$.
I would call Rick in the morning and ask him his opinion. He may have seen this problem before, and may recommend a solution. Could be you found something he didnt anticipate, too.
I'm not familiar with the lbz mouth piece, can you loosen it and rotate it up for added clearance? If so you'd just need a little linger intake hose.