My 2002 in my sig will not start.
On saturday I put on a lower valve cover gasket. Got it started ran just fine. Truck ran for about 10 min. I noticed coolant pouring out. It was the hard line going to heater core. I somehow cracked it. So I parked the truck till I could get a new line. That was on saturday.
I order a new hard line and put it in this evening. Go to fire up the truck and now it wont start.
I have fuel coming out of the bleeder screw at the fuel filter. I have cranked on the truck till both batteries are almost dead.
Could I somehow still have air in the injector lines from where I had to take them off? If so is there anyway to bleed them?
Any other ideas? I am stumped on this one.
On saturday I put on a lower valve cover gasket. Got it started ran just fine. Truck ran for about 10 min. I noticed coolant pouring out. It was the hard line going to heater core. I somehow cracked it. So I parked the truck till I could get a new line. That was on saturday.
I order a new hard line and put it in this evening. Go to fire up the truck and now it wont start.
I have fuel coming out of the bleeder screw at the fuel filter. I have cranked on the truck till both batteries are almost dead.
Could I somehow still have air in the injector lines from where I had to take them off? If so is there anyway to bleed them?
Any other ideas? I am stumped on this one.