I know theirs a thread on here about the best way to log tc lockup but i cant freaking find it. Can somebody point me to it? Thanks
tc logging
- Thread starter Muff
- Start date
Log turbine and input speed. Graph them on the same bar so it's easy to see when it locks up they will meet. If you need more room for pids just use tcc slip. If your trying to figure out if you need a lock up controller you need to log tc duty cycle. Full duty cycle on a 6 speed is 62.5ish and iirc it's 98. Something 5 speeds
Input speed and turbine speed are not graphing lines. They are both changing rpm but not graphing a line. I havent had this problem with any other pids before?