stainless housing

[fishsmith]

Who here sells the stainless housing for the 66/71 htt. I have a bullseye 66mm I assume it is the same thing. I know nothing about turbos.:rofl:

 

[othrgrl]

I'll check to see if I can get you one by itself.

 

[TrentNell]

they are expensive , i paid 350 for a used one , if i remember right it was 500-550 for a new one . worth the $ though if you have it .

 

[x MadMAX DIESEL]

HTT should be able to get you just the housing

 

[fishsmith]

The 66 I have is t3 and I think the stainless goes to a t4, Is this correct? If so I will have to get a new pedistal as well.

 

[Idaho CTD]

The stainless housings are T-3.

 

[othrgrl]

You need to measure the exducer on the turbine to see which housing you need. I can get you one for $550.

 

[fishsmith]

ok thanks. i will give you a shout tomorrow

 

[hondarider552]

is the 66/71/14 housing a t3 or t4???

 

[bullfrogjohnson]

is the 66/71/14 housing a t3 or t4???

Should be a T3, most all S300 turbo's have a t3 that I have seen.