Some codes to ponder

[mvnvltn]

The wife went out and jumped in for work. No reverse. p0841, p0846 set . Solenoids C and D stuck open. One other code was for reverse circuit malfunction but can't remember the DTC #. Checked fluid, cleared codes and sent her on her way. Fluid seemed a little airated?

Any idea's? This is on my 2002.

 

[Mike L.]

When's the last time you changed the spin on?

 

[mvnvltn]

50K miles ago or so.

 

[Bluemax]

Problem solved. More than likely.

 

[mvnvltn]

I hope. Cause my wifes mouth gets noisy when it acts up. How can I quiet that down?

 

[SIKDMAX]

By staying on top of maintenance? 50k for a spin on is a whileeeee

 

[mvnvltn]

By staying on top of maintenance? 50k for a spin on is a whileeeee

I'm pretty sure it was aroud 30k or so. I just pulled 50 out of a hat. I have been posting and driving today

I have an extra one i am going to throw on tomorrow. is 50K to long for an oil change?:joker:

 

[MaxFarmer]

I hope. Cause my wifes mouth gets noisy when it acts up. How can I quiet that down?

A good roll of duct tape?

 

[Kat]

A good roll of duct tape?

Just remember payback is Witch :witch::rofl:

 

[MaxFarmer]

:blah:

 

[LBZ]

I hope. Cause my wifes mouth gets noisy when it acts up. How can I quiet that down?

A good roll of duct tape?

:rofl::rofl::rofl:

 

[mvnvltn]

Well changed the filter yesterday. Again today I went out while cold 28deg. Same thing P0846, Now P0872 E solenoid stuck ? Could my pump be going bad? It works fine when its warm.

 

[mvnvltn]

Should I try a trans flush?

 

[Mike L.]

Stuck E shift valve.

 

[Mike]

I'm thinking my misery started when my clutches started coming apart. I had a really long code list. p0872 was the hardest to deal with for me, but after installing these Suncoast sets no more codes. Sorry to hear you have to deal with these.

 

[mvnvltn]

I guess I'll try to get to it this week.

Whick solenoid is the E solenoid? Can I just pull it and clean it ?

 

[Mike]

I guess I'll try to get to it this week.

Whick solenoid is the E solenoid? Can I just pull it and clean it ?

It's the middle solenoid in the part of the valve body that has 5 solenoids. I'll email you a picture. I'll try and load a picture here in the thread.

 

[mvnvltn]

Is it cleanable?

 

[Mike]

Is it cleanable?

Yep, done it thousands of times :joker:

 

[mvnvltn]

Grrrrrrrreat. thousands of time's. I'm so excited.

Would it be worth my time to clean them all?