Shim Mod, Race Valve/ Ported fitting

[TIM Z]

I run the PPE 350 tune,

Runs strong, never any codes or limp mode.

Do you guys think i would benefit from the shim mod/Race valve and ported fitting?? If so all or which mod?

Im always liking to tinker and do every little thing i can for performance, just wandered if i would notice any difference.

Thanks!

 

[Kat]

I run 12.5's in Wendy with no shims or race valve.

 

[TIM Z]

Thanks Kat, And Congrats on your E.T. and appearnce In Diesel Power!

I was wanderering if you did those mods. Good to know!

Need to get your ole man to tune mine!

 

[Kat]

Thanks :hug:

I believe all my mod's where listed in that article and where correct

 

[MMLMM]

I run the PPE 350 tune,

Runs strong, never any codes or limp mode.

Do you guys think i would benefit from the shim mod/Race valve and ported fitting?? If so all or which mod?

Im always liking to tinker and do every little thing i can for performance, just wandered if i would notice any difference.

Thanks!

The shim will not gain any more power, it will only stop help the ECM see an over pressure condition.

The ported fitting could help, it will allow more fuel. If you install it, you may "code" and have to do the shim/race valve though.

 

[LarryJewell]

I'd say both mods are worth doing