Long story short. A friend of my dads '03 melted hole #6
Ive sent the heads and block out. Block was sand blasted deck milled and honed. Cylinder heads rebuilt.
Everything is built stock.
I'm at the point of bolting on the cylinder heads But finding some issues with clearances.
Piston protrusion at .017" and valve depth at .018" intake .030" exhaust.
I have grade c head gaskets and new stock head bolts.
This is a coast to coast 30' goose-neck hauler
My question is can i get away with these clearances?
Where to by thicker gasket if not?
And would the stock bolts hold the thicker than c gasket?
...6 months of this i want it out of my yard. please help.
Ive sent the heads and block out. Block was sand blasted deck milled and honed. Cylinder heads rebuilt.
Everything is built stock.
I'm at the point of bolting on the cylinder heads But finding some issues with clearances.
Piston protrusion at .017" and valve depth at .018" intake .030" exhaust.
I have grade c head gaskets and new stock head bolts.
This is a coast to coast 30' goose-neck hauler
My question is can i get away with these clearances?
Where to by thicker gasket if not?
And would the stock bolts hold the thicker than c gasket?
...6 months of this i want it out of my yard. please help.