Ok my truck only came with one remote. I know the whole programming procedure but can't get driver 2 to take. It just keeps re programming driver 1. Oh. I recently got a driver 2 remote which is what I'm trying to program.
Help: Programming key fobs
- Thread starter CancerPipe
- Start date
How do you program them? I would like to program one myself
Built motor , duel fuelers , 60's overs , gtx4202r
Built motor , duel fuelers , 60's overs , gtx4202r
get in close all doors
hold unlock bottun on drivers door down and cycle key on/off on/off
then let go of unlock button
horn should chirp to start programming
hold lock and unlock buttons on FOB at same time for up to 15 seconds
horn will chirp again if it programs successfully
do as many FOBs as you like then
turn key back on to exit programming
hold unlock bottun on drivers door down and cycle key on/off on/off
then let go of unlock button
horn should chirp to start programming
hold lock and unlock buttons on FOB at same time for up to 15 seconds
horn will chirp again if it programs successfully
do as many FOBs as you like then
turn key back on to exit programming
i can get it to work just fine, but i cannot get the truck to take more than one at a time. i will program one which will show up as driver 1. then if i just program another one it becomes driver 1. so next i tried putting the truck in driver 2 with the button on the door and programming one, which works but as soon as you use the remote it switches back to driver 1, making the other remote useless. its like i cant get the truck to take more than one remote.
Figured it out. Once you get into programming mode program the remotes one right after the other. THEN exit the programming mode. I was exiting after each remote.