Allison 6sp: Ppe pto covers

[48548]

I am going to install the ppe pto covers this weekend. I would assume no sealant and was curious if I would loose fluid and the torque spec on the new bolts. Thanks guys.

Sent from my PG86100 using Tapatalk 2

 

[48548]

Using my trusty google, this is what I came up with...

38-45 ft lbs. Nice and no sealant and should be minimal to no fluid loss.

 

[combat_vet]

I know this thread is a few years old now, but I found this post via Google. I was trying to determine if sealant was recommended/required on the PPE Heavy Duty PTO Side Plate Cover gaskets.

The torque spec actually is 18-22 foot pounds, not 38-35 foot pounds. This come from Eric at PPE.

 

[wsmithduramax]

I would say sealant isn't required if your using a new gasket. Just my .02

 

[Mike L.]

I would say sealant isn't required if your using a new gasket. Just my .02

New factory gaskets have silicone beads on the gaskets.