i have read some threads about this here and dp. is there one on each of the fuel rails? also any of you guys run these and happy with the results? i though about just removing my stock ones and drilling them out, were are there exact locations?
ppe ported fuel valve
- Thread starter redws6rocket
- Start date
Depends on the motor Lb7 and LLY+ are different sizes and different fittings
Lb7 have 2 bigger fitting,but have a orfice that is seperate and sits downstream of the fitting
LLY+ have smaller fitting,but no orifice
On your truck you could drill out the rail fitting,It is at the end of the rail on the driverside closest to the front of the truck
Are you going to notice a difference? Not sure
Lb7 have 2 bigger fitting,but have a orfice that is seperate and sits downstream of the fitting
LLY+ have smaller fitting,but no orifice
On your truck you could drill out the rail fitting,It is at the end of the rail on the driverside closest to the front of the truck
Are you going to notice a difference? Not sure
I have the PPE version, put it on with the turbo, not sure if it helped, but for sure it didn't hurt.