p0245

[mde]

Just installed my DSP5 (which works great) but get now a p0245 code ABS ... what could it be?

Thanks ... V

 

[McRat]

Make sure you got Inch/MM right on speedo correction.

 

[beach_33]

my first guess would be that one of the pins on the connector to the ecm is not in all the way. they are very easy to overlook when one has been slightly pulled out

 

[Tired Old Man]

Make sure you got Inch/MM right on speedo correction.

Could you exsplain in detail Pat ( some people ME can't comprend )
Good to back

 

[mde]

my first guess would be that one of the pins on the connector to the ecm is not in all the way. they are very easy to overlook when one has been slightly pulled out

Thanks, that would be my guess either, on the connector C1 (blue by LLY) are the pins 46 and 53, I guess I will check them ... I had an incident as I unpluged the connectors

Anyway, other question: To connect my lift pump can I connect the fuuel pump relay on the C1 pin 44? On my sheet I see it's the fuel pump relais control, so should it work?

Volker

 

[LarryJewell]

Am I reading it right, you hooked the dsp up to the blue connector, pins 46 and 53, or you just had an incident with this connector?

 

[mde]

No, I had an incident with the blue C1 connector ... DSP5 is on greay C3 connector and pin 32 / 50 which works great.

But know the coolant fluid low shows up, and fluid is fine, no problem there ... I have to check the connectors again ... which is on C2 and pin 38 ... have to check that I'm getting confused ...

 

[beach_33]

just go through all of them and make sure that they are all snapped in. they can be a real pain