Oil cooler installed

[Chevy1925]

Bought brians oil cooler setup but being it was ment for a gmc from killer bee and i dont anything close to a stock bumper, i made it work. Came out super slick. Just need some corrigated steel to protect the cooler and she will be done.

Eventually ill get lights for the bumper again . Damn theives

Now for eye candy

 

[BLKLMM]

Not Bad for Turtle fab

 

[Chevy1925]

Yeah yeah ruben, dont you have a race to prep for?

 

[SgtKilroy]

Looks good! How'd you run the oil lines? A sandwich adapter? Not really familiar with KB's stuff.

 

[jmaz268]

id prob throw some sort of mesh over that hole to add a layer of protection.

 

[Chevy1925]

. Just need some corrigated steel to protect the cooler.

id prob throw some sort of mesh over that hole to add a layer of protection.

Smh john.....

Looks good! How'd you run the oil lines? A sandwich adapter? Not really familiar with KB's stuff.

yeah its just a sandwich adaptor that brian had bored to -12. I ran my lines completely different than you are suppose to cause im lifted and it was easier. Ill get some pics of that sunday. Goin snow boardin tomorrow

 

[SgtKilroy]

Nice. I'll look forward to those. I've been thinking about ditching the factory oil cooler altogether and putting a heat sink cooler/filter setup on the frame, but this is pretty similar to a remote oil cooler/filter setup I just did on a buddy's 6.0. It's really effective up front like that on his truck.

 

[hondarider552]

OoOoOoOoOo :woott:



I like James! :thumb: