Anybody know where I can get flow rate info on the ZEX Selonoid's. I spoke with one of the 16 year old sales people @ ZEX and he was stumped. Im trying to decide on hole size/Qty. for my IC C02 spraybar.
N20 Seloniod flow rate
- Thread starter RPM Motorsports
- Start date
super diesel
<<<< Under Pressure
Probagbly depends on the pressure attained. I would do at least a .125 selonoid and make sure it has port for a second stage. I would hook my stuff up and try it and then I could move to a extra selonoid if needed. Some one else will have to come up with the flow rate.
OPPS. I think I may have read this wrong. Do you already have the selonoid?
OPPS. I think I may have read this wrong. Do you already have the selonoid?
They don't think like that... as well the question you are asking has variables.
You'd want to speak with somebody with a brain, I would call NX for basic stuff.
For the time being try and poke around here... if you really get into it this is a cheaper less expensive alternative for what you wanna do and they can do some VERY trick N2O stuff if you wanna go that route later. They (Koehler) think in flow rates based on orifice/pressure line size etc etc.
http://www.koehlerinjection.com/Koehler/Comboflo/comboflo.htm
Shhh don't tell nobody.
You'd want to speak with somebody with a brain, I would call NX for basic stuff.
For the time being try and poke around here... if you really get into it this is a cheaper less expensive alternative for what you wanna do and they can do some VERY trick N2O stuff if you wanna go that route later. They (Koehler) think in flow rates based on orifice/pressure line size etc etc.
http://www.koehlerinjection.com/Koehler/Comboflo/comboflo.htm
Shhh don't tell nobody.
Last edited: