motor build

[02ilduramax]

well i think its almost time for me to pull the trigger and build my engine was going to hold off but figured i should probably do it before i break somethin dont want nothin to crazy and any suggestions on where i can get the parts i need for the best deal would be appriciated buil list is


rods
pistons
60% overs
headstuds
and i havent decided yet but i might put the s475 over the 366 but thats still up in the air

 

[whitelmmmax]

What's wrong with your truck to make you think you need a build? Good luck though. Should be a runner with that list:thumb:

 

[02ilduramax]

nothing at the moment it is starting to haze quite abit and ive wanted to do it for a while so i figured id go ahead and do it now when i have the funds

 

[bonomax]

trubo setup depends all on hp goals. s475 over s366 should be plenty of air to break hard parts like shafts and flex-plates in the trans.

 

[02ilduramax]

it has the s366 on there now and i have the 475 it was origonally for a project truck thats why it was still up in the air

 

[Fahlin Racing]

How much time do you plan on putting into this build?

 

[02ilduramax]

what do you mean time I am not in a huge hurry as I can still catch a ride to school with my buddy other than that I don't go anywhere to often..i don't want to rush it though

 

[Fahlin Racing]

Not wanting to rush is good. Removing all stress risers from oil pan to intake will help your build. However you must think which areas you can't remove the sharp edges due to a possible degrade in a sealing service quality etc. Oil drain back will benefit if the Dmax has any casting flash in the way that should be taken out.