Just remember, quantity has to be available to achieve higher rail pressure. Ie.. Lower pulse width as start, then raise till rail will not hold. Then just put the rail where you want it with pw as a control.
Modified Single CP3?
- Thread starter mick
- Start date
Just remember, quantity has to be available to achieve higher rail pressure. Ie.. Lower pulse width as start, then raise till rail will not hold. Then just put the rail where you want it with pw as a control.
Fixing th idle RP is not a problem anymoreI would reccomend doing the complete mod. Not just the regulator.
Got one stripped on the bench right now, I think there is a little room for improvement but I need to find out a few more particulars.
Bentley
Fixing th idle RP is not a problem anymore
So Joey, after all the drama is the end result noticeable and worthwhile?
There is a company that is stroking these pumps.
It won't be cheap, but I will be getting one to test soon.
It won't be cheap, but I will be getting one to test soon.
I'd be more than happy to mod mine with pic's, I just would like to make sure I know exactly what to do before I do it.
Travis call me up and ill help you mod the regulator i have a dremel at my house and if it works out good we will tare mine out and do it also.
Jared
I modded my lbz regulator a while back and noticed a gain in rail pressure.
Pat can you enlighten us more on this new "stroked" pump?
Pat can you enlighten us more on this new "stroked" pump?
FWIW, I ran my truck at the track this weekend and my mod'd reg held 21k+psi with a 3360pw on a single KD liftpump. The whole night was worthless other than some random data. Managed to squeak a 13.8 on a 2.9 60' though...
If the damn CAC boot would've stayed put I probably coulda FINALLY go a 12....
If the damn CAC boot would've stayed put I probably coulda FINALLY go a 12....
im thing of buying a new cp3 and sending it to wicked to get it modded for thier 650hp cp3.
Me could use mo fuel
Me could use mo fuel
i might have to start seling some uninstalled parts and my afe intake.....depends on how soon i want it
I want it so bad!
Yupper, not to hard, just gotta be very careful as not to damage any components. Its a free mod, well ita cost ya a couple of machine screws=pffttt , neglible to the cause
If your not comfortable, buy it done!
I did a little further work too mine then in the general outline of the mod such as port reliving & polishing some parts too
I haddnt had EFI to log data for pre/post comparo's but SOTP, its better off now