Measure injector cups for me?

[Sparkyman1]

2002 LB7 6.6L duramax

Looking for some to measure the Inside diameter of the injector cups with a digital caliper so I can make a compression fit tool with my 3D printer. I would do it but I would like to have the tool before I take my pickup apart.

Anybody have an injector cup laying around?

 

[WVRigrat05]

Why wouldn't you make one to go where your glow plug goes? They're already out there and a lot easier to rig up.

 

[Awenta]

Why wouldn't you make one to go where your glow plug goes? They're already out there and a lot easier to rig up.

I think by compression fit he means a tool to pull the cups out.

There's a write up somewhere. I think it's a 3/4 sleeve anchor bolt


Sent from my iPhone using Tapatalk

 

[TheBac]

Here you go: http://www.duramaxdiesels.com/forum/showthread.php?t=31371&highlight=concrete+anchor

 

[Sparkyman1]

Here you go: http://www.duramaxdiesels.com/forum/showthread.php?t=31371&highlight=concrete+anchor

I have actually seen that... I'm just doubting that it's exactly 7/8" and I'm going to need to be within 1/16" for a 3D printed part to work.. I think I'm going to make it a rubber cylinder with a hole in it with a bolt. Anyone else??