EFILive Looking for Tuning in Omaha NE area

[Dennon2009]

Is anyone on here from the Nebraska area. i just came in from working in AZ and im looking to have EFI put on my truck. i also have gauges and pod, pcv reroute, exhaust, and egr blocker plate to install. any good diesel shops around that would do all this and shoot me an estimate that isnt too steep?

thanks

 

[Texas Chevy]

Is anyone on here from the Nebraska area. i just came in from working in AZ and im looking to have EFI put on my truck. i also have gauges and pod, pcv reroute, exhaust, and egr blocker plate to install. any good diesel shops around that would do all this and shoot me an estimate that isnt too steep?

thanks

All that stuff that you already have and want to install can be done in your driveway for the cost of a 12 pack with a few basic tools. The EFI there are many vendors here that could send you tunes via email easily. Talk to some of the guys here. Plus there are instructions and DIY threads for all those things. Worst part will be the blocker plate install cause the bolts are tight as hell.

 

[Dennon2009]

what basic tools would be required?

 

[Texas Chevy]

Sockets and wrench. So wire cutters a drill. Not sure what's needed for the Pcv reroute but the install instructions are on the PPE website I believe. The blocker plate is a pain but it's two bolt you loosen. The exhaust is probably bolt on. Guages depending on your guages but a egt is just drill and tap then bolt it up and then route the wires a boost gauge is the same

 

[gmguy]

I'm about 2 hours west of Omaha.. pm me and I can help you

Sent from my HTC Hero S using Tapatalk