Longer wheel studs?

[RENODMAX]

Anyone know where to get wheel studs that are like 3/8" longer than stock?

 

[malibu795]

you looking at up gradign to 5/8" dia studs then.

 

[RENODMAX]

So is that a no Adam? I need a translator when you type :rofl:

 

[z79outlaw]

What are the lengths on dually studs? I'd look into that.

 

[malibu795]

What are the lengths on dually studs? I'd look into that.

iirc same as srw trucks

 

[dmaxx3500]

i looked for 3 months for longer studs for my 06' 3500 daully and never found any

 

[wikdlmm]

Ok ot but what do u guys think about wheel spacers?

 

[x MadMAX DIESEL]

I would like longer studs too, as I have a 1/4 wheel spacer. Is 5/8 much bigger then the 14mm? As far as fitting my wheels?

 

[Chevy1925]

I would like longer studs too, as I have a 1/4 wheel spacer. Is 5/8 much bigger then the 14mm? As far as fitting my wheels?

14mm is a bit smaller than 9/16". id say the 5/8" stud is about 3/32" bigger in diameter than a 14mm

 

[x MadMAX DIESEL]

Do they make longer 9/16 studs?

 

[x MadMAX DIESEL]

Noticed they make a 65mm and a 104mm one. Do i have the 65mm? Maybe i can justbget the 104

 

[x MadMAX DIESEL]

Are our studs 65, 80 or 104mm?

 

[x MadMAX DIESEL]

Did some measuring... My rear wheels studs seem to be the 65mm. Since I have about 48mm sticking from the rotor face. Tough to measure with the wheels on. But that leaves 17mm to come up with 65mm so makes sense. My guide is also rounded not square. Everything I can find leads me to believe I have front wheel studs on the rear axle??? The 80mm stud sounds like it would work fine, being roughly 1/2 inch longer... Anyone have an opinion?


What I am doing is mounting a wheel adapter onto the back. And my wheel already takes up 1 full inch of the stud.

 

[x MadMAX DIESEL]

Here's what I think I have on the rear.


Here's what I hope can work. Not sure about the part where it isn't threaded though.


And here is something very close in knurl and everything to the original but I would need new lugnuts.