log file - fuel in crankcase

[Chevmeister]

I took a quick shot of the truck tonight, commanded 160mpa. cant figure out how to get the pid to log in mpa and not psi. Desired 23000psi, actual 17200psi

balance rates taken from max and min values.
-1.33
-1.33
-2.34
5.75
2.91
-2.19
-2.00
-2.20
last night cyl 5 had a rate over 5 today its cyl 4. im assuming injectors are bad, but i hate to assume. Truck smokes a bit, and im going to mess with it tomorrow durring daylight. What else should I be looking at?

 

[MACKIN]

Leaking fuel lines.

 

[Chevmeister]

Ok, guess I need to start tearing it apart and follow the procedure for fuel leaks high pressure side?

 

[BTBP]

So i take it its not good when you command max rail pressure with leaking fuel lines?

 

[MACKIN]

So i take it its not good when you command max rail pressure with leaking fuel lines?

Could be


I'd pull the valve covers first see waz up........

The Balance rates don't look to bad to me.

 

[Chevmeister]

Pulling the valve covers is a PITA so im hoping to know what the deal is before I have to do that. Im sure theres more test to do before i throw money at it.

 

[MACKIN]

Check your fuel return rate to rule out injectors.

 

[Chevmeister]

How do I do that? I looked and EFI Live doesnt have a pid for return rate, or does it and i dont know what its called. Is it a manual procedure to test this?