LML pcv pil drain tube delete??

[Blackmax123]

While in the process of building a motor for my lml and trying to clean things up a bit to make it look like a built motor under the hood. I have decided to get a set of billet valve covers to go with all my powder coated parts.

The questions is does anyone know of anybody making a small billet plug that could go in place of the lower left hand corner of the front cover where the pcv separator oil drain tube bolts up so this tube can be removed as there will be no pcv valve housing on my valve cover.

 

[Blackmax123]

Here's a couple pictures of the hose to be removed for clarification. I could easy remove the lower part of the hose from the fitting that goes in the front cover and place a rubber cap over the nipple. But looking for something a little cleaner.

Something similar to the plug Fleece makes for the coolant return pipe on the rear cover.

 

[ChrisPerry]

You could always get a brass galley/freeze plug and tap in it.