LLY Truck Crank Signal Issue - P0335

[Shane H]

Ran the truck in my sig dry about 100m away from the fuel station. Was able to get it pushed close enough. Got it to run for 5 minutes but still had to haul it home that night.
Bled the return lines, bled the banjo fitting on the top side of the FICM. Bled the schrader valve by the alternator. Even bled a few of the accessible injectors. and both rails. Truck has a FASS 165. Filters are primed. Truck will NOT fire on diesel. I pinched the return line. Disconnected the FCA. Truck throws an intermittent P0335.

Edit* After much messing around, determined I did not run truck out of fuel. Ended up being a crank signal/rpm signal issue.

 

[kidturbo]

Sounds like it might have stuck the FP regulator. The P0335 is weird because it won't fire without the cam signal, but that's no ways related to running out of fuel. Need to verify you have decent fuel pressure on the rail for it to fire, and make sure you are getting RPM signal. Last look at that cam sensor missed pulse data and see if maybe it is a bad connection.

 

[Shane H]

I'll verify everything else next week when I get time to look at it again. Fuel Rail Pressure climbs to 27k psi as I'm cranking the starter and dwindles back down to nothing when leaving the key on accessory. Desired Fuel Pressure is asking for 5800-6k at start up. This is the same with the FCA plugged in and unplugged.

 

[kidturbo]

If it's making good cranking pressure, then most certainly it's electrical.

Sent from my SM-S901U using Tapatalk

 

[Shane H]

If it's making good cranking pressure, then most certainly it's electrical.

Sent from my SM-S901U using Tapatalk

Yep. Loaded up the parts cannon. Had the batteries warrantied as they were only generating half the CCA and threw a crank position sensor at it. Still P0335. And Ive verified that I dont have RPM signal.

 

[JoshH]

You need to be looking into that CKP code. Here's the diagnostics for it if you need some guidance on figuring it out.

 

[Ron Nielson]

Fuel Rail Pressure climbs to 27k psi as I'm cranking the starter ...... This is the same with the FCA plugged in and unplugged.

Yup, anytime the FPR is not powered for any reason, you get full fuel pressure. There is definitely a problem in the FPR or wiring somewhere.

 

[Shane H]

Another update. I did some diagnostics that I should have just done in the beginning. Following the document in this post. I found I could not get an RPM signal on my Edge CTS while tapping the signal wire in the crank sensor connector. Followed the instructions and uncoupled the BOTTOM bale connector on the drivers side of the engine. Did the same process and found RPM signal. My issue lies somewhere between the bale connector and the crank sensor connector.