lly injector rates

[LLYSMOKE]

Just picked up another lly has a slight mis/haze in gear went and tested the injectors today rates are
#1. 8
#2. -5
#3. -3
#4. -4
#5. -3
#6. -12
#7. -3
#8. -3


? Change the bad ones or do they all need replaced like in the lb7's you change one you do all?

 

[paint94979]

Although some of them are still in spec I would replace them all personally. However before you do just to rule out any mechanical issues I would move #1 and 6# around just to be sure they are in fact bad.

 

[02greysixer]

I would do some switching like paint said. Although doing the full set would be better you could start with just replacing the worst ones for now. The other rates may get a little closer to 0 after you replace that -12 and +8

Sent from my SAMSUNG-SGH-I337 using Tapatalk

 

[LLYSMOKE]

I replaced #6 I will test it today and see where im at. Thanks guys

 

[messejme]

With EFILive the injector that is indicated in balance rates is not actually the injector that you think. There is a glitch in the software. Try searching the forum to get the correct designation. I think this is particular to LLY,S. Please keep us posted on your project.

 

[LLYSMOKE]

With EFILive the injector that is indicated in balance rates is not actually the injector that you think. There is a glitch in the software. Try searching the forum to get the correct designation. I think this is particular to LLY,S. Please keep us posted on your project.

I used the new snap on scan tool. Truck still is missing a little after I changed #6 ill try messing with number 1 and 2

 

[SickLL7Crenshaw]

With EFILive the injector that is indicated in balance rates is not actually the injector that you think. There is a glitch in the software. Try searching the forum to get the correct designation. I think this is particular to LLY,S. Please keep us posted on your project.

Didn't they fix this issue??

 

[LLYSMOKE]

Just checked rates again #6 is perfect now #1 is the only high one im gonna swap it and see if my problem is solved

 

[Josh2002cc]

With EFILive the injector that is indicated in balance rates is not actually the injector that you think. There is a glitch in the software. Try searching the forum to get the correct designation. I think this is particular to LLY,S. Please keep us posted on your project.

I thought that was only when using the DVT controls?

 

[messejme]

It may be only in the DVT's but I wanted to make sure the OP knew about there being s problem. Last I heard Ross and the EFILlive crew had given IP on trying to fix the mislabeling injector problem.

 

[LLYSMOKE]

Fixed changed that #1 now runs smooth and no smoke all rates are now +/- .1