Put a DSP 5 switch and tunes in a buddies lbz, we got finished up, started truck, it ran for about 15 sec. Or so and started shaking then died, had him try again and it did the same thing, went and noticed it had lost prime so I pumped the primer and bled the air, had him try again and same thing happened, each time after it dies white smoke rolls out of the exhaust, I feel like it might be sucking air (fuel side related) not anything electronic related as I triple checked the pin location before installing. Does anyone have any ideas? If I did pin it wrong would it cause anything like that? Ran before we tuned etc... Didn't have time to troubleshoot tonight but was going to search for leaks put stock tune back in a recheck pins, he did say it was running rough here recently and started running stanadyne through it, but had been fine since