how to measure rods?

[Dallas S]

I have all the rods out of an LBZ and was thinkin while there out I should really measure them just to make sure there not bent. can someone give me the measurments or how to check? visually they look o.k. but my eyes only have a 1/16 tolerance...:thumb:

 

[cainer70]

a vernier caliper is your best bet

 

[duratothemax]

how do you measure them? By length!!! :

but in all seriousness, I would just take them to a machine shop. I doubt they'd charge you 20 bucks and it would take them about 2 minutes

 

[JMDuramaxLB7]

how do you measure them? By length!!! :

but in all seriousness, I would just take them to a machine shop. I doubt they'd charge you 20 bucks and it would take them about 2 minutes

X2...

 

[MadMaxx61]

vernier caliper X2 or blade mics or CMM ect.

 

[TimAT]

Measure center to center length, big end diameter and roundness, small end diameter and roundness, and parallel of the 2 ends.