Like it says I have a buddy with a twinned Lmm turned the overboost codes off still males the message come up how do I kill it?
LMM: how to gwt reduced engine power message to go away
- Thread starter DIESELMAFIAPER.LB7
- Start date
Cool thanka I knew it was simple just didn't know which table also have a question with his maf table is it possible to switch a frequency base maf to voltage base?
Let me rephrase that can it be done without the truck freaking out about it I have tried on a non twinned truck an it always throws a maf performance code
Let me rephrase that can it be done without the truck freaking out about it I have tried on a non twinned truck an it always throws a maf performance code
Last edited:
No Brandons truck has been a pain in the ass ever since we tried redueing the tune if we could read damn 06-up trucks wouldn't have had a issues but after GM reflashed back to stock I tried playing with the maf shit to make smoke an run similar to before an it gets pissed off throws a code puts truck in limp mode. He's been cool bout the whole thing bit I just what the thing running like he wants again
I had this same problem after I built the twins on my truck, after a few seconds at WOT the "REDUCED ENGINE POWER" message comes up on the DIC, but no DTC would set.
same issue on my truck, It's due to the MAF scaling, but I don't have the maf map for an lmm in my map list in EFI, so I'm not real sure how to rescale it. I max out at 76.3lbs right away and the dtc sets after it see's the actual vs desired off for 2 seconds.
There are tables for that. They C08... Somethin like that. They are the amount of time before dtc sets. The scaling is there too but not sure of the number right now.
Try adjusting the mixture tables? There was an LMM with twins that wouldn't fuel hard at all, I adjusted the Lambda and it started fueling harder.