What gauges do I need for my twins. Right now I have the edge insight, and I was going to utilize it as my pyro gauge, as well as monitoring fuel rail pressure. I was thinking 2 boost gauges. 1 for actual turbo boost, and another for drive pressure. I was thinking 60 PSI gauges but I am unsure if I need a 100 PSI gauge for the drive pressure gauge.
Gauges for twins
- Thread starter jrad12381
- Start date
I would go 2 100psi guages. MPI twins should run 1:1 if tuned right but i would get the 100's just to be on the safe side
a boost gauge for each turbo, a drive pressure gauge, 2 egt gauges, 1 pre and 1 post turbo, a fuel pressure gauge, 2 scan gauges, and a clock that looks like a guage 
I asked Nathan what gauges to run and he said he'd do a 100psi boost gauge. With regards to a drive pressure gauge, he told me I could if I wanted, but Rob has the tuning pretty dialed so it's probably not necessary.
What 100psi gauges are you guys running that would look good in a NBS truck? I have autometer GS series now and they match pretty well, but they only make up to a 60psi gauge in that style.
What 100psi gauges are you guys running that would look good in a NBS truck? I have autometer GS series now and they match pretty well, but they only make up to a 60psi gauge in that style.
Last edited:
a boost gauge for each turbo, a drive pressure gauge, 2 egt gauges, 1 pre and 1 post turbo, a fuel pressure gauge, 2 scan gauges, and a clock that looks like a guage
Don't listen to this guy or your truck will look like the cockpit of a fighter jet!!:rofl:
bring it down to jason we will have those on in no time
Sound like fun, but we will probably be doing the install here in a week or two.
