Front U-joint covers

[02freighttrain]

B & B Fab shops new Front Drive shaft covers for our trucks. They are 1/4" x 6" pipe and then some close measuring for a nice fit. They are overkill. No plans to sell them but here's a photo if someone is thinking about building some. They bolt through the bottom of the frame on both sides of the truck and are not visible. Fairly clean install. Good work TJ

 

[TNRGreene]

I like the one with the round braces....LOL Actually the front of the rear driveshaft covers

 

[fordt]

(Borat) Veeery nice....how much? :rofl:

Looks good! TJ is one hell of a fabricator!

 

[02freighttrain]

I like the one with the round braces....LOL Actually the front of the rear driveshaft covers

Corrected. Rear drive shaft, the forward U-joint.

 

[sweetdiesel]

Very nice!

 

[bullfrogjohnson]

Its about time Todd and Steve...haha

are yall drilling holes in the frame or are they factory hole?

I will post pics of mine when i am done

any pics on the truck?

 

[02freighttrain]

Its about time Todd and Steve...haha

are yall drilling holes in the frame or are they factory hole?

I will post pics of mine when i am done

any pics on the truck?

One 5/8" hole on the bottom of the frame rail, on each side. No pics on the truck yet.

 

[bullfrogjohnson]

any pics of the rear of the front shaft? Todd said yall would post pics when done.

 

[LBZ]

Is there a spec that the rules state that these things have to meet? As far as material amd thickness is concerned? For when we build some for Simon's 01 and when I do some for my truck-just so we don't get screwed by tech someday when trying to make a 10 second pass??

 

[2wd_Sled_Puller]

My rear one is a old lawn mower rim. Poor snapper

 

[LBZ]

My rear one is a old lawn mower rim. Poor snapper

:rofl::rofl:
Got any:roflics!!:rofl::rofl:

 

[bullfrogjohnson]

Dale, I dont think most drag strips have a rule on shields. I dont believe Casper runs any. But if yall do make them, steel has to be 1/4" thick and alluminum has to be close to a 1/2"

 

[LBZ]

Is that the pulling specs?
What about chain?

 

[ecc_33]

Thats exactly how mine is...One bolt threw the frame on both sides....Nice pieces

 

[ripmf666]

Loops and spring clamps we made for my truck.

 

[sweetdiesel]

looks good Henry

 

[ripmf666]

Thank You, that was the first set were going to redo them in alum and tig everything and make it better looking and lighter.think im going to start leaving them on all the time to be safe even if they dont call for then drag racing here.feel bad if something flew out and hit someone.

 

[BADDZL03]

Nice shields guys I could really use a set like that.:drool: