DSP 5 Voltage Question

[JD Dave]

My switch reads
Non DSP 4.97 volts
Non DSP 4.28 volts
#1 2.93 volts
#2 1.79 volts
#3 1.02 volts
#4 0.34 volts

Why do I have 2 non dsp voltages. Also Rob made me my tunes but where do I look in the tune to make sure these voltages match my tunes? The switch is from Socal Diesel and I thought it would only have 5 positions but it seems to have 10 or 12 so it's kind of confusing.

 

[JD Dave]

Well that was easy to find it in my tune. So my tune says:
#1 3.5
#2 2.498
#3 1.5
#4 0.499

Will my tunes all work with the voltages I posted up top. It seems there isquite a difference between them.

 

[1chevy02]

The voltages look good. As long as the actaul voltages are lower than what is in the tune. Look on the back of the switch, there should be a washer with a small tab on it. Put the tab in the hole on the back of the switch that has a small 5 next to it. That should give you five positions.:thumb:

 

[JD Dave]

The voltages look good. As long as the actaul voltages are lower than what is in the tune. Look on the back of the switch, there should be a washer with a small tab on it. Put the tab in the hole on the back of the switch that has a small 5 next to it. That should give you five positions.:thumb:

Thanks, I'll check the switch that sounds so easy I'm glad I asked. :thumb: