LBZ: driverside headlight low beam

[nc-12vpower]

low beam light does not work, but the high beam works. The passenger side low/high beam both work. Does anybody know what could cause this? All the wires look to be in great shape. i have low beam hid kit on truck, went and baught another box for the driverside and still not work.

 

[rickettzusaf]

Reverse the plug that comes into the box from the factory harness. We have reverse polarity on our trucks.

 

[JoshH]

Could be a blown fuse. Every bulb has its own.

 

[rickettzusaf]

That as well.

 

[nc-12vpower]

the hid bulb works on passenger side but not drive side. are you talking about the plug that goes into the hid box??

 

[MAXX IT OUT]

Try switching the HID boxes and see if you have a bad controller.

 

[nc-12vpower]

i have already tried switching the boxes. The wires on the factory plug is not getting any volts to it. but the passenger side wires tie into the driver side around the bottom of the radiator.

 

[Bustedknuckles]

i have already tried switching the boxes. The wires on the factory plug is not getting any volts to it. but the passenger side wires tie into the driver side around the bottom of the radiator.

Fuse, I used to keep blowing mine till I went with a relay harness from retrosolutions.

 

[nc-12vpower]

which fuse did you keep blowing? Where is it located?

 

[Bustedknuckles]

which fuse did you keep blowing? Where is it located?

Underhood fuse box, it is labeled.

 

[chevyburnout1]

i have already tried switching the boxes. The wires on the factory plug is not getting any volts to it. but the passenger side wires tie into the driver side around the bottom of the radiator.

They both tie into the same loom but as stated above they both have separate fuses for power.

 

[nc-12vpower]

okay thanks, i looked in the fuse box before but didnt see any that had left head light or whatever.

 

[nc-12vpower]

it was the fuse, thanks