Custom Intercooler tubing setups

[HSP Diesel]

Just wanted to show off some of our lastest builds, Here is a picture of a LB7 style bridge for an LBZ. We can do custom plumbing for any application!

 

[OregonDMAX]

Well that looks nice. And beautiful welds on that Y-bridge.

 

[sterlinLBZ]

what would you charge for a y-bridge and inter cooler pipe similar to this one for a lbz?

 

[joe@HSPDIESEL]

Pm'd!

 

[delong_1]

does this mean you have an in house mandrel bender?

 

[HSP Diesel]

does this mean you have an in house mandrel bender?

Not yet, But we are going that direction. We have a very good connection with the company that bends the tubing for us. All of the layout and design is done in house at HSP, then they do the bending. Some custom setups will have weld seams...

 

[Burn Down]

Any eta on the 3" hot side intercooler tube with a straight boot, instead of the factory 45*?

 

[mackthehack]

what would you charge for a y-bridge and inter cooler pipe similar to this one for a lbz?

X2

 

[delong_1]

Not yet, But we are going that direction. We have a very good connection with the company that bends the tubing for us. All of the layout and design is done in house at HSP, then they do the bending. Some custom setups will have weld seams...

i was just curious, we are looking to have some pipes done w/o seams. Just looking to keep our business with other diesel performance minded shops.

 

[HSP Diesel]

X2

We should have them within 3 weeks, I will post up when we have them ready to go.



Sounds good, well keep us in mind if we can help out in any way!

 

[mackthehack]

We should have them within 3 weeks, I will post up when we have them ready to go.

:thumb:

 

[Robby Avery]

Would like to see it installed

 

[joe@HSPDIESEL]

Here's the low profile setup installed.


Here's up over the alternator, which is what we use in the twin kits.

 

[Dozerboy]

Looks good I really like the low profile one.:thumb: