Current record for the Oval Race Cast pistons!

MarkBroviak

MarkBroviak

DMax Junkie
Vendor/Sponsor
May 25, 2008
2,134
464
83
Danville Indiana
Sorry about not posting this sooner but feel like it is still info that needs to be posted in here for everyone to see. To my knowledge Paul Vasko's rail when it was red it had LBZ Ecm and my ProMod engine in it. My promod engine which was a street motor setup with high compressions (18:1 iirc, Jon would know better than me) big cam and all the goodies in it you could or would want to do cool stuff. It's fastest pass was [email protected] and coasted to a 7.27 in the 1/4.(it ran a [email protected] at 3500lbs in my Promod). This motor is still together and is about to make its debut in another race truck of another customer of mine to run it in ODSS 6.70/5.90 classes. Just thought I would share with everyone and keep up the great work sir!
 
  • Like
Reactions: kidturbo, Leadfoot, Fingers and 2 others
kidturbo

kidturbo

Piston Tester
Jul 21, 2010
2,539
1,375
113
Somewhere On The Ohio
www.marinemods.us
Nice info.

I've seriously tried my best to kill em. Smacking 6000R's free spinning, directly into 100% load, 1750F sustained, like for several minutes at a time, sprayed down with 260F+ coolant, and I fed one engine a well shredded compressor wheel just for good measure. So maybe I didn't feed them enough garbage? I'm obviously losing my touch at this piston killing thing, they can't really be that tuff...
 
  • Haha
Reactions: Lennydmaxguy and MarkBroviak
2004LB7

2004LB7

Well-known member
Dec 15, 2010
6,982
2,145
113
Norcal
kidturbo said:
Nice info.

I've seriously tried my best to kill em. Smacking 6000R's free spinning, directly into 100% load, 1750F sustained, like for several minutes at a time, sprayed down with 260F+ coolant, and I fed one engine a well shredded compressor wheel just for good measure. So maybe I didn't feed them enough garbage? I'm obviously losing my touch at this piston killing thing, they can't really be that tuff...
Click to expand...
Have you tried pouring ball bearings down the intake? 😁
 
  • Haha
Reactions: MarkBroviak
Fingers

Fingers

Village Idiot
Vendor/Sponsor
Apr 1, 2008
1,715
86
48
White Oak, PA
FWIW. I've been running the Dynomite oval pattern injectors with very good results. Once I dial in my turbo tables again, I'll finish my review.
 
  • Like
Reactions: Bdsankey
1TRIKHD

1TRIKHD

Country boy Limo.
Sep 15, 2015
1,692
388
83
P.N.W
Fingers said:
FWIW. I've been running the Dynomite oval pattern injectors with very good results. Once I dial in my turbo tables again, I'll finish my review.
Click to expand...
I just found out about this oval bowl pattern. I already have 250% exergys with your oval bowl in a forged piston. Was thinking of possibly sending them to dynomite to see what they could do with them. I still have time to do it if I decide to.

Talking with Brad, he said he has had good results as well with them.
 
You must log in or register to reply here.
Top Bottom