Help: Cracked Bellhousing

[isuzulb7]

So today i was in the middle of pulling my motor and i noticed the bellhousing is cracked on my truck. Im just not sure Can i weld it and have it hold up? Can i pull the bellhousing with my motor out of the truck but my tranny in the truck? I need to figure this out asap. Any help would be apreciated.

 

[Mike L.]

You cannot pull the bellhousing while the trans is still in the truck.

 

[isuzulb7]

Ok. And I broke a tranny mount last year that must be why its cracked

 

[SmokeShow]

Can they be welded mike?

Mine is cracked for the second fuggin time. Ug. Has to be a driveline viberation? Wish a damn tree would fall on it, or stolen or something. Love it but hate it too.

 

[Mike L.]

They can be welded successfully. If I were going to do this I would strip bell housing of everything, totaly clean it and mount it on the block making sure the dowel pins were in place. I would install all the bell housing to adapters at the proper tq while welding it . I would then make sure I installed 2 new motor mounts and a new trans mount.