Can DSP2 Switch be wired into Tripp's overhead mount?

[MaxFarmer]

I have Guys 2 gauge overhead mount with the 2 switches. Neither one is being used AT THIS TIME. I want to use one for my e-locker switch if I can ever find a locker....
I got my DSP2 switch today, and as I see it, its just the pin for the ECM and a switch, correct? Can I just use my other switch in my overhead mount instead of the switch that came with the DSP2 kit?
Thanks,
Jason

 

[Kat]

Yes, you can

PS-Happy to hear the switch arrived :cool2:

 

[sweetdiesel]

did you get the 5 switch to?

 

[Kat]

did you get the 5 switch to?

I just sent him the DSP2

 

[Kat]

You can just use the pin off it if you want

 

[MaxFarmer]

Yes, thank you very much! After looking at the switch, I think trippins switch in the mount has 2 switched wires and the third terminal turns on the light when the switch is switched....
Do I have to take that switch out and put this one in or is there a way to use the switch that is already in there?

 

[MaxFarmer]

I deleted the other post b/c I thought there was only 1 wire to put into the ECM, now I see that there is 2... I'm gonna have to do some installation studying....

 

[Kat]

I deleted the other post b/c I thought there was only 1 wire to put into the ECM, now I see that there is 2... I'm gonna have to do some installation studying....

No, you where correct the first time. There is only one pin in the ECM. Guy made it so it could be either used for the LLY or LB7. You just cut the other one off. I will have to ask Pat which is which though.

 

[Kat]

Here are some instructions. I got off Guy's website.

http://www.socaldiesel.com/DSP2.pdf

 

[Kat]

You will be using the Blue one for the LB7. It's on page 15

 

[MaxFarmer]

Thank you very much! :book: