Blowby LMM

WVRigrat05

Wound for sound
Jan 1, 2011
3,081
4
38
36
French Creek, West Virginia


Is this too much blowby? Truck got 5 minutes or so of 4600 rpm's when my four wheel drive went out.

Dipstick blew out 1/4" and had a couple oil spots on the harness after the fact.

Oil smells burnt pretty bad.

Did not use any oil. Was a small drip from the pcv hoses.
 
Last edited:

WVRigrat05

Wound for sound
Jan 1, 2011
3,081
4
38
36
French Creek, West Virginia
Well so much for the video. I looked at an old video of mine from 3 months ago, it's fine. It just got hot enough to burn the oil.

Long story short, I was going the back way to camp I hadn't been in years, creek crossing was to my bumper, didn't like it so I went to back out and heard click and back tires started spinning, I was at least 3 miles from the nearest house and rough country so I rocked the truck easy for a few minutes romped on it a few times and got out.

Made it to the first big hill and only made it half way, went to hit it again and made it 20 from where I was the first time, went to that house I passed, got a ride called my buddy and we tried the easy way and it wouldn't go.

So, I went to town on the throttle, I'd go a minute and wait, and bored on it off and on until I burnt a brand new set of back tires off and we finally made it, I would have burnt that truck before I left it sit in that hollar. It would have been stripped or drug off before morning.