ok i'm stumped on this one. after i pulled my TCM file my right hand blinker is all messed up. when i put on the right hand blinker both sides go on like i put on the hazzards. the left hand side still works fine. what the hell did i screw up 
blinker problems after pulling TCM tune
- Thread starter tobyk321
- Start date
i did that it didn't help, it threw a trans code i forgot exactly what it was and of coarse i cleared it and now it won't come back. think it was MIL request circuit or some thing like that. guess if i drive around for awhile it might come back
oh i didn't see that you said re-read it. all i did was pull the stock one out, didn't put a different one in at all. so i can't see how that would mess anything up. you think reading it again would help?
Try re-reading it, then falash the one I sent you, be sure and save your stock one in several places.
One other thing, If you ran a script for an ecm tune, sometimes funny things happen, Like what your describing.
It takes a long time, but sometimes its better to copy and paste tables from the tune you are wanting over to your stock tune. I ran a script from an 04 lly several weeks ago to an o5 lly and immediately we were getting transmission codes. We reflashed in his stock tune then I manually made him a tune instead of scripting and all was good.
Long story short, if you scripted an ecm tune, that cold be your problem. Reading your tcm tune probably has nothing to do with your blinker or other code.
ok flashed your TCM in there and seems to have fixed it, just gotta take her for a spin now to be sure. thanks Larry
figured it out. i had my edge hooked up still :banging: thats gotta be what the prob was. i hooked it up to monitor my egt's but now its gone forever
Yea, a pyro would be a good idea
Im with Kat on not wanting to know how high they go
Years ago, when I first started getting into diesels I was told that real sled pullers don't run pyros. First off they don't want to know and sec what are they going to do...lift? :rofl: