ATS tranny problems

[Max'n 8]

for the last week or so i have been having a delayed "reving" shift up into 2nd and a hard down shift into 2nd. It has limped me twice and stuck me in second yesterday. I cleared the codes and and was so pissed i didnt write them down but remember these two for sure P0700 and P0747. Im sure it will happen again and ill the other code today. Also had a delayed "clunk" in reverse. The reverse thing only happens about once every 5 times i back in my driveway. fluids are fresh and full. I have this feeling its gonna involve pulling the valve body out (again) but any ideas would be apriciated. Thanks IN advance

 

[TrentNell]

P0747 .................... hopefully clutch material isnt what is making it stick on What does the fluid look like ? its possible a electrical problem could make it stick on too I guess . I would drop the pan , pay attention to the fluid and cut open both filters and see what they show , if there are no signs of debree then it could be valve body or electrical .

 

[McRat]

Change the spin-on, check the fluid first off.

 

[maxaholic]

I hear ATS has great transmission warranties. I would give them a call.

 

[Max'n 8]

this is the same valve body i sent into ats for the same reason before. Except that time it was clutch materal sticking the E Valve. Only difference is once it happened that time it was down in limp mode, this time i can clear the codes and it runs fine for a day or two the does it again, clear codes and its good for a day or two. Are there any steps i should take before dropping the pan?

 

[Max'n 8]

changing the spin on today.

 

[Max'n 8]

I hear ATS has great transmission warranties. I would give them a call.

this way is easier

 

[maxaholic]

Lol

 

[Mike L.]

Give me some codes. It helps alot.