As I reinstall my motor....

[SIKDMAX]

What parts/gaskets/bolts/etc. am I going to need?

The motor is complete pan to valve cover, injectors installed. All I can think of so far is torque converter bolts. What else?

What else would you do as it goes in? For one I'm going to bolt the motor mounts.

 

[slowlmm]

What parts/gaskets/bolts/etc. am I going to need?

The motor is complete pan to valve cover, injectors installed. All I can think of so far is torque converter bolts. What else?

What else would you do as it goes in? For one I'm going to bolt the motor mounts.

i would figure out your turbo set up first wether you go with that htt.or twins ect alot easier to plumb and istall every thing while the motors out. if the motors complete you shouldent need any thing but mabey some trans fluid and cooloant

 

[SIKDMAX]

Going to put the HTT on for now. Twins this summer.

 

[SINCAL_DMAX]

Let me know when you get that thing done. I want to check it out.

 

[sweetdiesel]

batteries charging?

Extra oil and filters

 

[SIKDMAX]

Thanks Simon

Have 2 new optimas for it, 12 oil, fuel and trans filters sitting here, and 6 gallons of Mobil 1 diesel oil. Also several jugs of dexcool.

Think I'm covered there. Any seals or anything else?

I'm excited

 

[sweetdiesel]

Thanks Simon

Have 2 new optimas for it, 12 oil, fuel and trans filters sitting here, and 6 gallons of Mobil 1 diesel oil. Also several jugs of dexcool.

Think I'm covered there. Any seals or anything else?

I'm excited

Make sure your boost tube off the HTT is going to work...you might want to get a new style boot

 

[SIKDMAX]

Where would I get something like that?

I havent looked at the install kit yet... will I be able to use my S&B Intake from my stock setup with the HTT or do I just go to a K&N style cone filter?

 

[MMLMM]

dont forget a new set of spark plugs. And make sure there gapped correctly before installing them.

 

[SIKDMAX]

Thanks Mike

 

[LBZrcks]

Did you do anything to your motor mounts yet?

Oil pan tapped? Easier to do it while it's still out if you plan on running twins.

 

[ripmf666]

I would install new glow plugs

 

[slowlmm]

I would install new glow plugs

whys that ?

 

[stacks04]

maybe new ac compressor seals. sometimes they are fine, sometimes not. if you split any lines.

 

[Vrabel]

how old is pump/converter seal? may want to change for preventive maintainance

 

[RENODMAX]

Replace anything that was broken or lost

 

[ripmf666]

whys that ?

Just to be on the safe side,That or look them over and make sure they did not have any AL stuck melted to them.Better safe then sorry with his build,He has alot more into his then yours or mine since he had it built for him.

 

[SIKDMAX]

A few more parts too.... Assembly was only $2500

 

[duratothemax]

A few more parts too.... Assembly was only $2500

yikes. Thats why I built mine myself.

 

[SIKDMAX]

I like to have people to yell at if I have a problem :joker: