911 After New Turbo Setup

[kivetts04dmax]

ok guys, idk where to put this so mods please move anywhere..

I did a remote mount on my truck, Ported fuel rails, I removed the plug I had in but it still runs the same, and relocated ficm..truck has a lopey idle and it's choppy like an exhaust leak when I drive it..it just has the dp on it right now..NO CODES!! what can it be?

I also had to take the fpr and two injectors out but nothing should of gotten any dirt on them..

 

[SgtKilroy]

It may not have cycled enough times to trip a code yet. Did you extend the wiring harness for the FICM when you relocated it?

 

[RENODMAX]

You have a lot of things going on being that you took injectors out, modified fuel rails etc. Why don't you get a log of your truck to start pointing you in the right direction?

 

[kivetts04dmax]

yes I extended the wires 2'..I did them one at a time and used heat shrink connectors and wrapped them all in a waterproof tape..

 

[kivetts04dmax]

You have a lot of things going on being that you took injectors out, modified fuel rails etc. Why don't you get a log of your truck to start pointing you in the right direction?

I just have Internet on my phone..I logged the data but need a vehicle to drive somewhere that has wifi lol

 

[kivetts04dmax]

If the truck is running how can I check the wiring on the FICM? Will they all be hot?