1/2 inch cp3 fuel fitting

[2500HeavyDuty]

so i went and ahead and made a new fuel fitting for my cp3 while i had my engine on the stand.

the stock fitting had an area of ~.0422 square inches at the smallest point.
The modded fitting i made has an area of ~.0683 square inches.

trying to bore out the stock fitting to that size is not possible the fitting would be destroyed. heres some pics.

 

[skintback]

looks good can you send me two

 

[dbev24]

looks good can you send me two

X2 how much would u want for them?

 

[2500HeavyDuty]

X2 how much would u want for them?

i never thought about selling them, it isnt that hard to make if you have a vice and you can solder pipe together.

i basically hacked the end off of one of these: http://www.napaonline.com/Catalog/CatalogItemDetail.aspx?R=GATG623000205_0000999999

and welded one of these in it: http://www.napaonline.com/Catalog/CatalogItemDetail.aspx?R=TEM201312_0214955855

oh btw here is some funny hose: http://www.napaonline.com/Catalog/CatalogItemDetail.aspx?R=GAT85971_0000999999 :rofl::rofl:

 

[2500HeavyDuty]

you have to drill out the part of the fitting that screws into the cp3 since the new one will be the same size as the stock one.