Search results

Search the forum Search Articles
  1. K

    Factory Frame Wire/hardline clips/brackets

    we do show clips in our catalogs that secure pipes and brake lines to the frame. not all wiring harness retainers are shown. sometimes with those I measure inside diameter and then look for aftermarket comparable
  2. K

    Replaced DEF Heater - Reductant System Malfunction Level 5

    You'll need to go through the glow plug control module and manually command each DEF heater (should be 3)to run for at least 15 seconds. This way the system can see the new amp draw and qualify the system is ok per se
  3. K

    Rear Diff Fluid Change

    Ok so if you’re going to replace the yoke there are a few extra steps to take. Remove rear axle shafts from diff. Then take your dial inch pound torque wrench, use adapters and socket to place it on the pinion nut. Then turn it and measure the rotating torque. When you install new yoke, seal...
  4. K

    LB7: Dampener

    This would be a chance to upgrade over factory. I think last i checked the factory damper at my cost is over $400. Companies Like Wagler sell good used factory ones if you’re looking to save some money as well
  5. K

    Rear Diff Fluid Change

    Center punch pinion nut and pinion in-line to each other before removing. Then when going back together tighten pinion nut slightly past being inline with mark on pinion . This will put proper load back on bearings and crush sleeve
  6. K

    P0113 IAT Error when LMM in Reverse

    jack up the rear of the truck and set axle on jack stands to keep wheels off ground. Then put vehicle in reverse and start your testing. Might need to have one of those brake pedal depresser or if you got a good holding parking brake. James is probably right is my guess. As the motor shifts...
  7. K

    02' LB7 Tow Pig Build

    Yeah $330 shipped is a deal I don’t think anyone could pass up. Even the $500 they are priced at ain’t so bad. But then you sit back and think are they going to run it again at that sale price and you wait lol. That’s my “cheap a$$“ mind set
  8. K

    02' LB7 Tow Pig Build

    Uh I missed that sale when they had it. I too believe that the OEM cam could be improved a bit. Is wagler's cam already keyed? I'd assume so but I can't remember if Austin told me they were or if its extra. Is their cam kind of spec'd like comp's stg1 LST cam?
  9. K

    02' LB7 Tow Pig Build

    Hey Brad, why the Wagler stg 1 cam vs other companies stg 1 ? I’ve never got to put a cam in a Duramax yet and every time I do a Cummins they always want a Hamilton.
  10. K

    04.5 Duramax LLY getting p0101

    Wiring repairs definitely easier on the wallet than hard parts. After you do the repair get a piece of dense 1/2 thick adhesive backed foam and put over that alternator bracket and then zip tie harness just snug to it.
  11. K

    04.5 Duramax LLY getting p0101

    Just remember egr is a stepper motor and not directly connected to the egr valve. the stepper motor can move properly but it’s possible for the egr valve to get hung up. Especially from open to close
  12. K

    Dmaxstore Connecting Rods

    I have a set of lml rods In the garage. The Dmaxstore ones that are in the photo on their website look identical to them.
  13. K

    Happy Birthday Mike L.

    Happy Birthday Mike !!!
View older results
Top Bottom